Fabric Cutter Styrofoam Cutter Hot Knife Heat Cutter Cutting Tool for Rope

Description

Item specifics
DIY Supplies:Electrical
Type:hot knife
Aliases:hot cutter
Product Description
We have two kinds of 110V and 220V heat cutter. Please leave a message and tell us which kind of hot cutter you want。
Otherwise we will send you the type of hot cutter that is suitable for you in your country.
Description:
This heating cutter is a kind of convenient and practical cutting tool specially for cutting polyester fabrics, such as fiber banner.
The fabric hot cutteris a wonderful tool with good cutting effect.
There is no rough burr after cutting.
The heat cutter tool is power saving and easy to operate.
The temperature cutting blade can go up to 500°C for which rising to 500°C it takes within 6-8 seconds.
Also, the structure is reasonable and comfortable for using. Most customers use this heating banner cutting tool to cut fiber banner or other advertising fabric graphics well.
Specification:
Voltage: 110
Frequency:50/60Hz
Power: 100W
Speed: Adjustable
Temp.of blade:6-8 seconds heating up 500°C
Length of the Wire: 3M
Dimension: 24 x 4.5 x 3.5cm
Packing Size: 28 x 23 x 8.5cm
Gross Weight: 0.7kg
Application
：
hot knife cutter, used together with different type blades,
can be used for cutting different materials.
Blade Installation:
1, Use the Allen Key loosen the screw in the copper clamp.
2.Insert two pins of the blade in to the copper clamp, and then
tighten the screw, make sure that the clamp is touch enough
with the blade, if not the blade will not work well.
Cutting Process:
Optional Accessories
1.Turn the temperature adjustment to the middle place, put the blade
in the goods for cutting, and then press the switch. Only seconds,
the blade will heat up, before real cutting, suggest do the trial cutting
in the waste materials
2.The temperature adjustment have 16 steps, you can check that the
line in the knob, when the line is longer, that the output power larger.
3.Make sure the harmony of temperature and speed when cutting. If
there is too much smoke, reason may be slow cutting or the overheated.
It will lead to irregular and uneven cutting for the materials.In this case,
need to adjust the work temperature of the blade or loosen the switch
intermittent when cuttin
4.Loosen the switch, when there is only 3-5cm before finishing the cutting.
5.Please clear the residuum in the blade by copper brush after cutting.
Notices:
1.Please make sure the tool is used under condition of ventilation.
2.Don’t burn the residuum in the blade, the blade will be crooked.
3.Don’t burn the blade without touching the cutting materials.
4.Don’t touch the blade by hand when heating, and don’t put the
blade near to the inflammable after heating.
5.Handle the blade after cooling to avoid scalding.
6.Make sure the suitable output power and cutting speed,
overheating will burn out the blade.
7.Intermittent operating for the tool, suggest that loosen the switch
for a second after 30 seconds’ working